Common problems and Methods of Ore Crusher

Iron ore crusher and grinding mill used for processing plant,Iron ore crusher is the key processing equipments in beneficiation plant,it is mainly used to crush iron ore into small size for further processing.
With the advent of low-carbon economy, the mining machinery industry is facing a new test of 'green, energy saving, emission reduction', a good business not only be able to withstand such a test, but also take such a test as part of its development and growth momentum. Hxjq ore jaw crusher is the ideal equipment to meet the dual demands of market and business development.
Hxjq is China famous ore jaw crusher equipment R&D company who keep up with the trend of times, insist on technological innovation and talent development strategy. The ore jaw crusher has been obtain outstanding achievement in energy saving. The new ore jaw crusher type was researched and developed based on the traditional jaw crusher machine. Meanwhile adopted advanced design concept to optimize crusher body shape and reinforced the weak parts. The improved ore jaw crusher gained more good performance, such as larger capacity, lower wear and consumption, large crushing ratio and so on. The new type ore jaw crusher is suitable for the material crushing compression strength not higher than the 320Mpa, such as the ore, rock, slag, etc., the material blocks shall be not greater than the technical parameters. This ore jaw crusher machine is widely used in the industrial sectors of metallurgy, mining, chemical, cement, construction, refractory and ceramic pieces and crushing of various hard ore and rock.
When one mining ore crusher machine is used for a long time, taking iron ore crusher machine for example, without change the wear parts or using new wear parts replace the old ones, it may appear that the vibration increases suddenly. Usually, it is caused by the factor that rotor is not well balanced when replacing or assembling blow bar. The best way is reassembling the blow bar and balances the rotor.
Sometime, the outputs may be oversized when the machine has been used for a long period. These questions are usually caused by wear and tear of the hammers and impact plates leading excessive gap. At this time, there are two methods that able to solve these problems, one is adjusting curtain rod setting. The other is changing the hammer bar and impact plate.
The following problem is not easy to be fond, bearing temperature is too high. It is very easy to damage the bearing. This problem is usually caused by , for example, insufficient lubricating grease and dirty lubricating grease are used. Also, the worse is that the bearing is damaged. To this situation, operators can check the amount of the lubricating grease, clean the bearing and replace the lubricating grease and replace the bearing. Different solutions are for different problems.

The article is provided by Hongxing company,As the professional manufacturer of complete sets of mining machineryArtificial sand washer, Henan Hongxing is always doing the best in products and service.